what is the meaning of Ring Mean Unit in a substation or
trasformer also tell me its oerpuse?
- 4 Answers
- 48650 Views
- NPTC, NTPC, I also Faced
- E-Mail Answers
Answer Posted / hesham
RMU IS used to feed the transformer from two different feeders within ring
1- TRM ( two incomer and one outgoing feeding only one transformer 2+1 )
Or ( 1+2 ) one incomer and two outgoing feeding two S/S.
2- QRM ( 2+2 ) two incomer and two outgoing feeding two transformer
or ( 1+3 ) one incomer and three outgoing feeding three s/s.
| Is This Answer Correct ? | 19 Yes | 5 No |
Post New Answer View All Answers
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
Give two basic speed control scheme of dc shunt motor?
what is the use of Auto re-closer?
what is the terminal voltage of dc series generator running at rated speed at no load?
what is consequences of neutral and earth connect?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
In parallel operation time both NGR’s close or not close if both close what will happen
what is the function of impulse relay
how to calculate cable size in diffrent loads?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
internally connection of photvoltic module
why does a dc machine has high efficiency while working as a generator than as a motor ..
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
