Interested to Buy Any Domain ? << Click Here >> for more details...
How to select a cable size according to load
- 1 Answers
- 4461 Views
- Red Bull, I also Faced
- E-Mail Answers
Answer Posted / nasarudheen m
The max. load can appeared across the cable indicates the max.current
is flowing through it.so with the increase of load causes sufficient
incriment in cable insulator. so cable insulator detemines the size.
| Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
Difference between ac parallel circuit and ac series circuit?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
a battery is having capacity 100AH and 25% charging .if a load taking 10A & connected 6 hour .what is the final condition of the battery.
HOW TO CALCULATE S/C,O/C,E/F OF ACB.
Why does the rotor rotate?
what is rocking arrangement in arc heating
what is the carona effects meaning in HT line transmmission system
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
1.4 What is meant by CT knee point voltage and how would you determine it
Do you need any help with FEWA Electrical Supervisor exams?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
