Interested to Buy Any Domain ? << Click Here >> for more details...
in what way biot number is differ from nusselt number?
- 3 Answers
- 12127 Views
- I also Faced
- E-Mail Answers
Answer Posted / shashank
biot number is used In partial unsteady state heat transfer and it is the ratioof conduction resistance of that body and external convention resistance of fluid.....( means when a solid body is surrounded by a fluid )
where as nussult no corresponds to fluid ie fluid layer which is just near the solid body ( assume pipe ) acts as solid and type of heat transfer is conduction here..... and above this fluid layer convention is taking place....
nussult no is the ratio of this conduction resistance of FLUID to convention t resistance of FLUID....
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?
What is difference between overall heat transfer coefficient & individual heat transfer coefficient?
What is the wet bulb globe temperature (wbgt)?
What are the some common problems associated with dilute phase pneumatic conveying?
Explain what is the significance of the minimum flow required by a pump?
Hi.. Me going to tke test for management trainee(technical) Post I am an chemical engineering student . Can u guide how to prepare for this test.Can u send me test paper pattern..?
What industries require filtered compressed air?
whats the allowed tolerance of pipe to pipe butt joint mismatching
When an expansion is joint needed on the shell side of a shell and tube heat exchanger?
Explain under what circumstances are vortex flowmeters the most accurate?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
hai please please if any one have useful test related and interview based question plz send me at saify_0@hotmail.com i will be thankfull
What is a good source of information for the design of pressure vessels?
What does capacitor load means? How does it connect?
What is a good estimate for the absolute roughness for epoxy lined carbon steel pipe?
