Answer Posted / rishabh jadia
Transformer ratings are in kva becoz total
losses in transfomer only depends on voltage
and current but they do not depends on phase
angle between them i.e. power factor (pf).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In dc ckt. 24v or 110v, which one is more efficient and why?
Did RMU have ct and pt ?
which protection used in power plant?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
Difference between a pilot wire and a normal conductor?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
how we explain parallel paths armature winding?
Can anyone tell the proper diagram of star delta starter????
kindly send me 11KV MV motor differential protection procedure by primary injection method.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
how r charge carriers produced
how to calculate vfd o/p voltage by frequency
What is shunt voltage and u v voltage witch one best
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
Efficient electrical earthing in hard rock area
