Interested to Buy Any Domain ? << Click Here >> for more details...
what are the installation requirement is common to all flow
meter when volumetric flow rate is being measured
- 1 Answers
- 3707 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
The (mostly unstated and assumed) common requirement for all
commercial flow meters is a full pipe.
The presence of air or gas in a liquid line not only causes
an inaccuracy in the measurement, in many cases it can cause
the measurement to fail altogether.
A close second for common requirements is to avoid vertical
downflows for liquids.
Carl Ellis
Measure First
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
What is Span Error
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
How to Calibrate Ultrasonic Level Transmitter in field
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
How to calibrate the flow transmitter
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Valve positioner and actuators in detail.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
i want to find out iffco get test paper
What is first echo & echo window in radar type level transmitter?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
