Interested to Buy Any Domain ? << Click Here >> for more details...
In power plants the reading changes abruptly to give value
(MW -25) (MVAR -15)
What are the reasons for this?
What is the solution?
- 2 Answers
- 4885 Views
- GE, I also Faced
- E-Mail Answers
Answer Posted / sonu pal
MW is active power and MVAR is reactive power.
Active power, P= V.I.cosΦ
Reactive Power, Q= V.I.sinΦ
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What is the difference between grid and off- grid system??
How to design the NGR Resistance
In what condition the HT fuse breakes?
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
What are diffrent type of road taxes?
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
What is “pu” in electrical engineering?
how to calculate IR value of 33KV cable ??
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
Why you want to join non technical field when you are an engineer?
