Interested to Buy Any Domain ? << Click Here >> for more details...
single phase 230v three phase voltage 415volt why we aren't
used line voltage 690v?
- 7 Answers
- 23936 Views
- Citec, I also Faced
- E-Mail Answers
Answer Posted / hassan
In 3 phase (RYB) one Phase remain zero other one positive and one negative. if we draw 3 phase (wave)diagram .
so voltage is 440 not 690
V+0+(-V)= 2V
0+V+(-V)=2V and v=240
(-V)= V because it is magnitude
similarly
8 combination
| Is This Answer Correct ? | 11 Yes | 4 No |
Post New Answer View All Answers
list the type of vfd? wich is sutable for heating kiln?
what is maxemo work permit procedure
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
what is the safety points of vaccum circuit breaker.
What is the difference between grid and off- grid system??
what is mean by PIR in circuitbreaker and give me detail of that?
What is cut-off rate?
List the time domain specifications.
Why is voltage is required to be within permissible range for an electrical equipment?
What is the formula to calculate a three phase alternator
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
