Interested to Buy Any Domain ? << Click Here >> for more details...
Why we Do not connect the windings of the
motor in delta? & what would happen if we
do that?
I mean the winding themselves not the
three lines that are coming to the motor?
- 1 Answers
- 3344 Views
- I also Faced
- E-Mail Answers
Answer Posted / sarmadahmed
One reason is because we need a neutral for grounding the motor so the winding of motor is connected in Y.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
What is the effect of pi controller on the system performance?
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What is meant by system?
why on delay timer used for fully automatic star delta starter?
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
how braking & making capacity of circuit breaker are calculated?
