Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if we give DC supply to AC motor?
- 9 Answers
- 37351 Views
- I also Faced
- E-Mail Answers
Answer Posted / onkar wadkar
when we given dc supply to single phase induction motor,the
single phase motor has two windings 1)stator wdg2)rotor wdg
when we have gave dc supply then in case of single phase
induction ind motor the stator side ckt acts as a purely
restive then max vtg get get dropped across the wdg and
their is no flux linkages according to the faradays law of
electromagnetic induction,and hence no emf gets induced and
consequently the motor will not start...and it results into
damage the winding of the motor...
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Define noise?
What is the slip speed?
Describe the control mechanism of missile launcher???
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
10 Mtr Hight of Lighting Arrestar how much area coverd??
What is the maximum percentage voltage drop (vd%)for a motor control center
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
What are the classifications of oscillators?
what happens to the supply voltage if there is any change in frequency?
what are the differant std sizes of cable trenches?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
