Answer Posted / nagarajan
Normally using All low torque application such as pump ,compressor and airlock valves etc.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Why PS class CT is always preferred for Differential protection?
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
What does the letter CTNM in negative phase sequence relay means?
What is routh hurwitz stability criterion?
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
What is different bewteen low or high impedance busbar protection scheme
What is negative sequence over voltage element?
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
Why is the air gap between the pole pieces and the armature kept very small?