Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pankaj rathi, bajaj group.
Its a final control element. used to control the physical property of materials.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is loop1 and loop2 in MTS LT?
what is cems analyzer explain with principle and drawing ?
What is instrumentation instrumentation engineering?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
I need to know steps to Calibration Valve Guard......
How oil line flow measured?eplain about instruments used and working principle?
protection relay watchdog contact operation?
How to calculate P,I&D value in PID controller ?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
what is effect of specific gravity in differential level transmitter , explain formula related with this .
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
