Interested to Buy Any Domain ? << Click Here >> for more details...
in an open circuit. test there is no
load curent..
but secondary. ia open then no
urrent have to flow
but there a smaller current flows
why?
- 4 Answers
- 6518 Views
- Rubber Park, I also Faced
- E-Mail Answers
Answer Posted / sheikh
May be megnatizing current of transformer.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what is a power factor?
What is the type of feedback used in an op- amp schmitt trigger?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What are the advantages and disadvantages of open loop control system?
why we testing the core balance of the transformer before comissioning?
How to discuss the phase shift of transformer considering open delta?
What is electrical grounding?
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
what is meant by moulded case circuit breaker ?
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
one electromagnet is called
