WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?
- 26 Answers
- 37476 Views
- APTransco, BARC, I also Faced
- E-Mail Answers
Answer Posted / sanjna singh
LIGHTNING ARRESTER IS PLACED ON THE TOP OF DISTRIBUTION POLE..
WHEN THERE IS LIGHTNING IN SKY IT EFFECTED DISTRIBUTION LINE THEN THE ARRESTER CAPTURE IT AND GROUND THROUGH THE POLE........
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
what are the steps involved in generator load test?
what is high and low cut off voltage of BB and DG at SPS????????
at which voltage level arcing ground is occurs ??????????
Define what is power quality meter ?
How to synchronization will be done between two DGs ?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
why need to be maintain power factor for industrial customer?
What is the size of a 60 watt and 80 watt tubelight?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
what is submersible pump?what is different between motor and sub motor?
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
