Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sanjana singh
when dc is fed to the t/f then the current flow in primary winding but it is not in alternating nature so there is no mutual inductance take place. if d.c continuously fed to t/f after a limit the t/f may burn out.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Can an inverter be used as a converter? How?
how to calculate energy of 3-phase motor?
can u please mail me the syllabus for GET exam for damodar valley corporation?
what happen if drive input fail momentry at 48.5 HZ frequency?
will there be any problem by recovering slip from single phase induction motors?
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
what happens to the supply voltage if there is any change in frequency?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
Explain what is rated speed?
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
Determine the BTU size of an aircon for 20 sq metre room
How to decide DO set rating of Transformer?
