Interested to Buy Any Domain ? << Click Here >> for more details...
WHY 6.6KV MOTORS ARE STAR CONNECTED AND WHY NOT DELTA CONNECTED,
- 15 Answers
- 35092 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / keyur lakhani
because,in 6.6kv we reqiure high starting torque so that we use star connection and also line voltage=root of 3 *phase volage
and also in this motor we connect more load so current drawn by this motor is high so we reduce by star connection
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
and gate circuit diagram,amplifier circuit diagram
How do we find the rating of a transformer, if it got burnt badly.
what is the range of maximum DOL and SDS can be use for pump and fan application
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
What is different between resistance grounding system and resistance earthing system?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
how we explain parallel paths armature winding?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
how external lighting design? please give examples?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
What is the most accurate way of testing ELCB?ELCB is better than RCD?
Explain the working principle of Synchronous Generator and Assynchronous generator?
