What is double delta conection in AC Motor? And can we done
the double RPM of the motor by double delta conection?
- 1 Answers
- 11733 Views
- vguard, I also Faced
- E-Mail Answers
Answer Posted / gurusaran
Double delta connection is used to achieve reduced voltage
during start up of a motor by changing a delta connected
winding from parallel groups to series groups.This is termed
as "double delta connection" because the delta winding is
connected in series during start up and the same is connected
in parallel during running condition with the help of a part
winding starter.Since all winding's are connected in starting
as well as running conditions the amount of heat generated is
not so severe.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to decide choke rating for drive?
there are cam operated switches - why we call cam operated , What is cam ?
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what is high - pot test. what's its use?????
At what factor resistance r of a conductor depends?
why we need to us lenz's law for synchornous motor
what is interfacing in computer studies?
132/6.6ππ πππππππππππ πππππππ πππ πππ πππππ πππ πππππππππ. πΈ'ππ πππππππ πππππππππππ ππ 6.6ππ/415π πππ πΈ πππππππ πππππππ ππ ππππ πππππ πππ ππ ππ 13/6.ππ πππππππππππ?? πΈπ π½π.. ππππ π ππ’??
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
