Interested to Buy Any Domain ? << Click Here >> for more details...
Quick setting cement's setting time?
Answer Posted / udhaykumar
Quick setting cement : - In the cement, the initial setting time is starting from 5 mnts & also 30 mnts (final setting time) will change to hard state..
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the density of DLC & PQC and how it is differ from normal concrete?
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
how to calculate MR 9(derivation)
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
How do you calculate load bearing capacity of a waffle slab?
What is bmc stands for in bmc software?
what is the specific gravity of rubble in plum concert
if dia of inner circle is 42 m and depth is 1.5 m and width is 1 m ,then whait is the quantity of steel?
why do we not deduct volume of steel to find actual volume of concrete in practical???
I need Bhel engineertrainy test papers in civil engineering please send to email id - hisandy66@gmail.com
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
What is the meaning of soil reinforcement?
qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
What is the use of extend command?
