Suppose you have hot fluid and cold water, what fluid you
should flow in shell side and tube side in a shell and tube
heat exchanger and why
- 6 Answers
- 10383 Views
- I also Faced
- E-Mail Answers
Answer Posted / nameh
hot and cold fluids are not well defined. the most important
criteria for tube side fluid selection is corrosive
potential, scale deposition possibility and maintenance
requirements. upon exact definition of fluids; information,
specially hot fluid, the judgement can be performed.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can anybody give me syallbus of chemical engineering for section engineer in railway.
What are some common problems associated with bellow expansion joints?
which materials can l use if l want to use length wave 680 to 900 in hplc
Why in a continuous plant for a Hot standby screw pump system the interlock for auto starting of the other pump ( when the running pump stopped suddenly) is given with header pressure only? why not with flow rate or current of the pump?
Should slurry pipes be sloped during horizontal runs?
i need last year question paper of GATE exam of chemical stream.but i failed i geting exam papers.soits humble request to u that if any body found last years GATE exam paper of chemical stream then send it to on this mail address.i shall be thankful to u for this. mail address:- sachin_4255@yahoo.co.in thank you.
How can you control the ph level in our cooling water with respect to ammonia contamination?
send previousyear question paper for ongc gt 2011 chemical engineering written exam
Is there any way to repair a valve that is passing leaking internally without taking our process offline?
What is minimum flow required of NG having BTU value of 920 btu/scf for flame stability of LBTU gas of BTU value 220 BTU/SCF against the flow 80KPPH.
Explain some of the consequences of an undersized kettle type reboiler?
Do you have recombinant protein expression experience? Explain?
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
What is a good source of equations for calculating discharge flowrates from accidental releases?
What diffrence between flush distillation & batch distillation ?
