Interested to Buy Any Domain ? << Click Here >> for more details...
In an panel board if the outgoings are power plugs and
motor equipments...what should we choose as the incomer of
the of the panel board?? MCCB OR ISOLATOR?? Should we use
ELCB protection??if so where??
- 2 Answers
- 4731 Views
- I also Faced
- E-Mail Answers
Answer Posted / vbn
Thnk u for ur answer sunil sir.but if we use mccb as
incomer..what we will do to protect the motor from earth
leakage??shoud we use an ELCB near to the motor equipmnt??or
should we use an ELR relay in mccb connected via cbct??
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
BSNL TTA EXAM QUESTION
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
briefly explain the main blocks found in a microprocessor based system
Where can I get Iidian straderd specifications for electrical items or works in web? please help me.
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
aternator every parts and its working
How we select the vector group of 3phase power transformer?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
please send me previose rrb junior engineer qustion papers
how choose conductor&depending upon load
can some one clearly explain why -48 volt DC use in telecom site????
What are electric motors?
