Interested to Buy Any Domain ? << Click Here >> for more details...
Is it possible to connect a dYN1 transformer in
parallel with a YNd11 transformer.
- 4 Answers
- 16146 Views
- I also Faced
- E-Mail Answers
Answer Posted / pramit dutta
according to condition of paralleling of two or more 3 phase transformer banks ,the phase shift between primary and secondary voltages must be same. it follows that all transformers in same main group can be connected in parallel.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
How to Calculate the Fault Level of Electrical Installation
Should power factor be low or high?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
What are the different types of transformers?
WHAT IS DEAD END IN PROTECTION?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
Is it possible to measure the voltage of a battery from a single terminal?
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
Pls explan the OLR setting in VCB at HT yard
why and where we use early make & late break contacts in protection?
What do you mean by an instrument transformer?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
