Interested to Buy Any Domain ? << Click Here >> for more details...
To calculate temperature, why we multiply 25 with mV?
- 2 Answers
- 7998 Views
- I also Faced
- E-Mail Answers
Answer Posted / greenborhan
I actually don't know why we multiply by 25, but for
your better knowing we don't get the correct cut result
by multiplying mV by 25, this procedure is only true for
k-type thermocouple. But for all other types of
thermocouple you have to follow the specific table for mV
and temperature.
greenborhan@gmail.vcom
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is IEC code in cables & how to selecting cables?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Why MUX JB's are using only Temperature Element in Fundation field bus?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What is eddy current? Describe the operating principle of proximity probe.
What is cut off relay? And why use in PLC and DCS?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
why we are using magnet for calibration of gas detector?
Linear amplifier.
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
What is Positive Calibration and Negative Calibration?
Why boiler chimney area oxyden sensor fixing?
In turbine what does term CDP, NI, NH, HSSOC means.
What are different types of valves?
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
