Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / guest
posinar
| Is This Answer Correct ? | 0 Yes | 11 No |
Post New Answer View All Answers
What are different types of cable?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
what is diffrance between FF & SMART, explain with difination
Tr. Wiring for calibration.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
detail of mass flow meter pricipal
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
