How do i calculate material requirements for various concrete
ratios, brick masonry for 1 cum?
- 3 Answers
- 5727 Views
- QER, I also Faced
- E-Mail Answers
Answer Posted / maulik
A standard brick vollum is 0.19*0.9*0.9 divaid by 1 mater cub and show your no of bricks.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate thickness of MAT slab & Reinforcement? The dimention of under ground water reservoir is 80'X14'X 12 ft
5. Do you feel that your present employer estimates your full work potential? Are they pleased with your work performance?
What is meant by scaffolding coefficient?
what is idealized curve for concrere and steel
What is the best type of wood glue?
How much the quantity of Dry material of Crush for 1:2:4 Concrete, using pan 3/8'' down....
Advantage of Aluminum form work in terms of activities can be skip and cost too
What are the different softwares used for cad?
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
How to arrive the co- efficient of all civil activities? For ex:- painting-enamel in wooden doors. co efficient is 1.8. How this is calculated
why & what is perchatage we are using fly ash in concrete?
What are segregation and bleeding?
Define What are the uses of alloys in daily life and how are alloys made?
Draw a neat sketch showing the 'throat' of a welding in a plate girder ?
