Interested to Buy Any Domain ? << Click Here >> for more details...
why we use DO Fuse in H.T. Line ? What is the purpose of
DO Fuse
- 4 Answers
- 49303 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.ramesh
Why we use DO Fuse in HT Lines?
DO - Means Drop off.
*We do use DO Fuse in HT line for isolating the faulty bit
of Spur line.
What is the purpose of DO Fuse?
*Actually it is called as DOLO. ie., " Drop Off Lift On ".
One end of the fuse wise is tied to Supply end of DOLO unit
and the other end is connected through a stone to delivery
end of DOLO unit with stone hanging. When there is fault in
spur line the fuse wise cuts than because of gravitational
weight of stone the stone tied piece of fuse wire falls
down. there by supply will be isolated. After clearing the
fault the same way the fuse may be provided using 11KV
Hickory Rod with safety gadgets.
*No need for taking Line clear for carrying out maintenance
of this spur line. Remove the fuse, attend the maintenance
with making safety zone, observe safety rules, wearing
safety gadgets after completing the work provide DOLO fuse
restore power supply to the spur line.
*is provided in 11KV Spur lines for isolating spur line
during fault occurs.
| Is This Answer Correct ? | 26 Yes | 2 No |
Post New Answer View All Answers
what is conductor constant of raccun conductor
Usage of flywheel diode in relays
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
give me atleast four differences between circuit and network
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
wat is the first thing dat is needed, 2 lay a cable in some area??
What is the difference between grid and off- grid system??
Fantio of tranformer
hello friends.. I have a doubt regarding the operation of dc machines.. I studied in a text book that a dc machine can be used as a generator and as a motor.. is this possible? If so,please send me the info about this topic.. you can also send your info to my mail.
how to avoid Saturation in C.T?
What is polar plot?
What is meaning of out of phase (making & breaking) capacity And how to calculate
whats the existence of reactive power and when it arises?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
