Interested to Buy Any Domain ? << Click Here >> for more details...
If i want use the 6 kg/cm2 pressure gauge then how to
calculate its pressure gauge range?
- 1 Answers
- 3927 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
The general rule of thumb is to put the working range in at
the mid-range of the scale of the pressure gauge.
Remember, a bourdon tube is damaged beyond repair when
overpressurized.
Alternative rules are
If the working Range is
- Steady: the working range can be 3/4 of full scale value
- Fluctuating: the working range should be 2/3 of full
scale value
- Full scale value: the gauge is working near its limit.
Short duration at full scale value is advised. Replacement
with a higher range gauge is advised.
Typical standard dual scale gauge dial ranges are shown below:
kg/cm2 psi
0-1.06 0-15
0-2.1 0-30
0-4.2 0-60
0-7 0-100
0-10.6 0-150
0-11.0 0-160
0-14 0-200
0-21 0-300
0-28 0-400
The 0-11 bar-Kg/cm2 range puts a 6 kg/cm2 working value just
above mid range.
Yeah, yeah, I know. 1 bar is not exactly 1 Kg/cm2 but we're
talking mechanical gauges here.
Carl Ellis
Measure First
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Using your own examples solve a problem involving normal table. (experimental method and analysis)
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
What is ultrasonic flowmeter?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
Explain about safety integrated level protection? . How it was differ from other protections ?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
how to calibrate load cell
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
How to calibrate capillary type level transmitter
What is the use of gauge?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
How INtools is useful for routine Instrument maintenance?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
