Interested to Buy Any Domain ? << Click Here >> for more details...
Is voltage & potential transformer are the same? Are they
used for same application ?
- 11 Answers
- 17950 Views
- I also Faced
- E-Mail Answers
Answer Posted / vels
yes friend
PTs are connected in Bus side or Line side
used for metering and
protection for Distance relays ,directional overcurrent relays ,under/over frequency relays ,under/over voltage relays ,synchronising Gens and Lines
open delta measurements
line healthy etc
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the common earth
defination of transistor controlled series capacitor
why chock were used in old tubelights but are not newest tubelights?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
how we can calculate the efficiency of a diesel generator ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
why constant voltage transformer should be start without load? and if started then what will happen?
what is Fan Control Cubicle
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
Why the earth to phase voltage is high 250 compare to other two phases
What is VSCF windelectrical system?
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
