Coarse aggregate & fine aggregates are called inert
material when used in RCC work because------
Answer Posted / veeneet naik
because sand are filling void and aggregate for strength
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
What is the difference in painting using Roller and Brush? What is the paint consumption difference? As per IS one coat of painting is painting from left to right and top to bottom whether this can be done using roller ( Roller Stick height and feasibility) ?
How to calculate the quantity of cement mortar 2" for mosaic tile fixing 12"x12"?
How do you change a dimension value in solidsworks?
Will water damage concrete?
how many kg of 20mm, 10mm, dust available in one ton stone boulder
what are the proper pipes for salt water line
what is that one cub metre plaster in cemant and fine sand
What is gravity flow?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
How much permissible bearing capacity requires for open footings(isolated) and what type pile foundatuon prefering for coastal areas?
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
how can we calculate steel value, depending on load
for G+2 residential building how much quantity of required in foundations,sub & superstructures per sq ft area
What are the basic use of runners and standards of pipelines?