What is function for Load Bank test and why need to test.
Answer Posted / pillay
A LOAD BANK IS USED AS A SUBSTITUTE as load to test the performance/ ability of a generator set.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
Give some differences between open loop and closed loop?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
1.What is captive power plant? 2.What is national grid?Give brief idea.
How does a transformer contribute towards the widespread popularity of ac system over dc?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
List the disadvantages of constant k filters?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
What is the cut-off rate?