Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer fuse wire is very thin as compared to home
fuse wire while voltage lavel is low
- 1 Answers
- 4251 Views
- I also Faced
- E-Mail Answers
Answer Posted / danny
fuse is 2 breaking excess current hence transformer has less
current but high voltage,in home the voltage is already
transformed into current hence bigger resistance wire is needed
power is transported in form of voltage 2 avoid loss as
power loss is current/votage
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
should %impedance be high or low in a power transformer? if so why?
WHat is the general checks required for Dry type transformers
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
How will polarity test of Dy5 Transformer ?
what is the write prosidure of stringing of 8meter pcc pole.
work of choke in florocent tube circuit ?
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
Where voltage are high and current to be interrupted is low the breaker preferred is:
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
What is inverse definite minimum time lag relay? Where is it use?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
