Interested to Buy Any Domain ? << Click Here >> for more details...
what is the standard of determining opening/closing time of
Motor Operated Valve?
- 1 Answers
- 5285 Views
- I also Faced
- E-Mail Answers
Answer Posted / jim lowe
By accessing manual mode, force the motor fully closed, then
force it fully open and time how long it takes with a stop
watch.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
need instrumentation job completed 1 year trainee ship in mnc pesticide company. now in search of job
How to Calibrate Level Switch in field
what is the input of digital counter during the the calibration time?
how to calibrate corollaries (Mass flow meter)?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
how to commission furnace ( water heater)
What is the difference between modbus,fieldbus & profibus
What is the cascade control
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
How to erection of DCS Panel at site step by step
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Explain PID, ON/OFF, Controls
