what is Basic Engineering.,FEED and Detail Engineering with
respect to Electrical Engineering.(Explain with Example)
- 1 Answers
- 3278 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
The Basic Engineering FEED required for proper installation
is to follow the required details of the code that is
required. Engineers find it difficult to do this because
few have been taught the laws of engineering with respect
to Electrical and Detail Engineering. The rules such
As the starting of a dc motor and syn.motor and induction
motor high current flowing through the winding cause the
voltage to reverse polarity. this can cause the windings to
burn out. To avoid this different types of starters are
used. But incase of transformer what Will be used. At
starting no emf is induced in the primary winding.
1. If we apply dc supply to the primary winding of
transformer it will be burnt out. similarly dc supply is
given to field winding of syn. motor and armature winding
of dc motor, they are safe. Remember both windings are
inductive in nature.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
What type interview questions ask in Electrical technicians
how invertor convert the dc into ac give brif detail
percetans
Determine the BTU size of an aircon for 20 sq metre room
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
what is frequency response?
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
difference between servo motor and synchronous motor
what is magnetizing current test in power transformer
Why reactive power is needed in a power system? How is it being absorbed or delivered by alternators? For reactive power control we are changing excitation but reactive power absorbing or delivering related to stator. How these two are interlinked? i want a detailed explanation with necessary expressions and figures?
what is sevice settings for mccb?How can be it setted?
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
