Interested to Buy Any Domain ? << Click Here >> for more details...
State 5 different method of level measurements.
- 3 Answers
- 6829 Views
- SRACO, I also Faced
- E-Mail Answers
Answer Posted / hitesh
five TYPE OF LEVEL MEASUREMENT
1> DIP TUBE METHOD
2> DIFFERENTIAL PRESSURE METHOD
3> ULTRASONIC METHOD
4> NUCLEONIC METHOD
6> RADAR TYPE
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
What are different types of orifice plates? State their uses.
Define cryogenic?
i need some objective type questions in instrumentation
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
how to commission furnace ( water heater)
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
what is thermo coupler and how it works
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
