Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pasupathy
stiffness factor is equal to the ratio of the product of the moment of inertia of the cross section and the modulus of elasticity for the material to the length of the member.
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
how can check the resistance of battery contact?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
what is there inside an inverter and how it works?
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
What safety precaution are to be taken for avoiding electric hazards ?
why different series of vfds (like allenbradley)are used in industry ?
can the measured percentage error during calibration of single phase energy meter be negative?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calculate MCB Breaking capacity.
What is meant by short-pitched winding?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
What are the disadvantages of hydropower?
