Interested to Buy Any Domain ? << Click Here >> for more details...
3) How earthing is done? How it measured? Write the method for earthing? How the earth resistance is kept low?
- 1 Answers
- 4979 Views
- Innovative Energy, I also Faced
- E-Mail Answers
Answer Posted / karna
Method of earthing is Pipe Earthing and Plate
Earthing .Earthing we are Provided for Electrical
components by using copper cable or copper flat etc..
Earthing can measure in Ohms by using earth tester. By
pouring water regularly, adding coal and salt for every six
months
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What is capacitance?
How to maintain ac plant?
hi every body i am master student in control engineering and my project is slip control in trains i assumed a Dc motore as traction motor but i don't have characteristics of this kind of motor that is used in train. i want from every body if he or she has the characteristics or information about Dc motor that is used in train give me those information or technical characteristics .
What are the essential characteristics of signal flow graphs?
Which types of gate insttaled in static switch. Please give me answer.
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
how to find out 3 phase complex power in per unit in unbalanced system?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
How to calculate the fuse rating depend upon the DC circuit?
Differentiate between real and apparent power?
what happened when we supply a dc current in dc motor?? can it worked properly?
