Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between stress and pressure?. what
is the difference between moment and torque?
- 69 Answers
- 113759 Views
- College School Exams Tests, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / shams parwez
STRESS= the internal resistance developed due to the
application of external force.
PRESSURE=force per unit area
| Is This Answer Correct ? | 230 Yes | 46 No |
Post New Answer View All Answers
For conduction of heat, the instantaneous rate of heat flow is product of three factors. What are these ?
What are the causes of liner high temperature?
DEAR SIR, I NEED A MODEL QUESTION PAPER OF JSPL. i'M IN mechanical BRANCH. E-MAIL ID:sksuman289@gmail.com
What is the use of divider?
Is critical speed temperature dependent or speed dependent or both?
What is the percentage of carbon in cast iron ?
sir most regardly i want previous papers of your company for my preparation of my written exam
What parameters to be reported when we send lubricating oil for shore analysis?
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)
Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison
Who are the leaders among expansion valve manifacturers? what are the recent developements in the expansion valve industry, used in refrigeration abd air-conditioning?
In process control loop e/p converter receives 4-20 ma input current from which control block?
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
Who all falls under the Perview of Excise Duty, we mean who has to pay the Excise Duty, eg: does all mfrs have to pay ED or who has high turnover they should only pay ED, if yes that what is the Turnover limit?
