Interested to Buy Any Domain ? << Click Here >> for more details...
why should we have to maintain excess air in furnaces and
boilers while burning any fuel?
- 6 Answers
- 13400 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / suraj chaudhari
To avoid smoke formation by burning fuel
completely, so rediction of particulate matter. Also
for obtaining high calorific value of fuel.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
When should one be concerned with the tube wall temperature on the cooling waterside of a shell and tube exchanger?
What is the maximum recommended velocity for steam in a plant pipe network?
Hi.. Me going to tke test for management trainee(technical) Post I am an chemical engineering student . Can u guide how to prepare for this test.Can u send me test paper pattern..?
Explain what types of metals are typically removed via chemical precipitation?
Is it advisable to cool a fin fan by spraying demineralized water on it?
any meter avilable for measureing the Transformer Losses. ( like Voltmeter for voltage & ammiter for currenr )if yes plz give the make & supplier address, Email, Phone number.
Explain the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
How can viscosity affect the design of a mixer?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
how can we calculate reflux ratio? what is difference between internal reflux and external reflux?
Repected sir/Madam, I am goingb to face IOCL technical as well as HR interview, can you forward your hellpfull hand for toward me to sort out my problem by giving some imp interview quetion which is generally asked in chemical industries such like IOCL,HPCL,ONGC,BPCL,RIL,etc I will always thankfull to you,for sharing your profficient knowledge with me and making me somewhat technically sound
What are some good estimates for heat transfer coefficients for coils in tanks?
What are the different characteristics that can affect the flow of bulk solids and how?
Is there a quick rule-of-thumb to estimate a gas side heat-transfer rate inside the tubes of a shell and tube heat exchanger?
