Interested to Buy Any Domain ? << Click Here >> for more details...
What are the Safety measures in central chiller plant?
Explain them?
- 22 Answers
- 67603 Views
- Carrier, CPIC, HSL, JLL, I also Faced
- E-Mail Answers
Answer Posted / kiran .j. anjutagi
1)Voltage variation.
2)High temperature.
3)Low temperature.
4)Oil temperature.
5)HP and LP switch.
6)condenser moter VFD.
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
how to measure dc earth leakage current?
wheather the size of windings in motor and generator are the same
What is knee point voltage of transformer?
Why the cores of large transformers build up of circular cross section?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
Which capacitor is preferred for high voltage and frequency?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Tell me all plants load factors i.e which plant operating on which load?
How is operate breaker failure scheme in substation
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
