Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between pneumatic and electro
pnematic positioner?
- 3 Answers
- 36604 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / mallu byali
it will work as a trnsducer from 0 to 15 psi which is
convert by 4 to 20 ma ele signal. it has flaper mechanisum
no any role apply on this.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
How we connect a instrument with ground, Give brief explanation with help of diagram?
how to calibrate steam control valve in steam turbine
what does it mean an active front end in vfd plz explain it briefly
Can anyone send most commonly asked interview question in Oil & Gas industry
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
how is work pressure switch& level switch?what is the principle of this?
How to Calibrate Level Troll in field
why we are using digital signals for I/O & how to measure this signals is getting or not ?
Programmable Logic control.
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
what is piezoelectric transducer?give an example in power plant n state its principle?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
