Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by phase transformation ratio in induction
motors?
- 2 Answers
- 15324 Views
- I also Faced
- E-Mail Answers
Answer Posted / adnan khattak
THE ration between Rotor turns and stator turns is
transformation ratio in induction motor.
k= rotor turn per phase/ stator turn per phase
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
full form of flry b
What is dynamo function in DG sets and draw block diagram?
How much dc volt applied in cathodic protection system?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
can u give me a brief idea about power line carrier communication ??
How select ELCB for 32amp. socket having quantity 12Nos. We have to do this wiring in PLANT. Please Also explain the incoming cable specification.
At full load wat is the motor p.f And at no load will is the motor p.f?
What is different between Difnit time and instatous over current relay
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
How Can you do Maintenance of ACB of 2000Amperes
what is your majour contributions in your present job
