Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / samad
when place near two coil and supply the one coil then flux
is create around the coil and these flux cut the turns of
another coil and flux is create that coil and emf is
produced.this is called mutal induction
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
How many capacitors using in LT panel as per Govt rules?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
What is meant by positive and negative feedback?
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
what is the power rating of CPU, CRT type moniter, LCD type moniter,scanner Approx.
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
3phase motor can be used as a Prime mover for alternator.
what is KA rating and how can we choose switchgears on applications
How to design harmonic filter at the project stage without nowing the harmonics levels
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
