Answer Posted / razib
Pyranol
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
What are the disadvantages of autotransformer?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
how to read idmt curva
Why are lt windings placed near the core?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
why and where we use early make & late break contacts in protection?
what is conductor constant of raccun conductor
why the pf of semiconductor device is improved the electrical devices
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
How to calculate that clean water supply in one Day from 150 KLD STP?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
Classify drilling machines.