Answer Posted / kishor
basically function of boiler is to generate steam in a
closed vessel.In plant boiler used to convert steam pressure
into electrical energy.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to calibrate load cell
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
what will the sending unit in the fuel gauge utilizes?
Question on maha cement
Exothermic reaction./ endothermic reaction
what is maxdna ?. explain about the software details.
How to decrease opening & closing time of on/off valve?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
what is the reason while warning lamp is on while the engine is cranking?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
Which is your favourite subject & explain any one topic of it.
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.