Interested to Buy Any Domain ? << Click Here >> for more details...
What are the precautions to be taken before working on a
cable?
- 1 Answers
- 4513 Views
- Alfanar, I also Faced
- E-Mail Answers
Answer Posted / sheikh
If cable is disconnected from both side then no any precaution
required but if cable connected from one or both sides then
before starting any work on cable discharge the residual
charge by connect every one lead of cable to earth momentary
and during the work cable should be remain short to earth
to avoid any possible electrical charge.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
Enlist four components of electrive drives.
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
What is different between Difnit time and instatous over current relay
any one please tell taht what type questions will be asked in BHEL interview, i am having interview on 24th Dec, please send this to mail pradeepsistam@yahoo.co.in
What are the advantages and disadvantages of short-pitched winding?
what is the difference between megger and earth resister ??
What is the mmf,rgt and ngt please brief completely
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
How calculated single phase induction motor req. Capacitor?
What is the function of RCBO? What are the different sensitivity ratings & each application?
given data are load current & power factor cable core size? plz any one update the calculation formula
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
