Interested to Buy Any Domain ? << Click Here >> for more details...
can any one tell leakage class in control valve depend on
which parameter and there is any specific table or chart for
selection of valve leakage class
- 2 Answers
- 6082 Views
- I also Faced
- E-Mail Answers
Answer Posted / narayan sharma
It mainly depends on the fluid property passing through the
control valve i.e temp, viscosity etc.
Eg for Steam application we have to select ClassIV leakage
class,ClassVI can't be used for the same, as Class VI
leakage class can be achieved by using Metal to Soft
sealing & soft sealing can't withstand this high
temperature.
hope this will resolve ur query.
Best of luck.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are advantages and disadvantage of the ac supply load cell?
Exothermic reaction./ endothermic reaction
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
What is the difference between modbus,fieldbus & profibus
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Name different types of bourdon tubes.
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
what is the difference between magnetic flow meter and mass flowmeter
Tr. Wiring for calibration.
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
how the arrangement of equipments done in control room
full process of gas turbin?
