Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nagarjun
In any electrical ckt we requires
return path to complete a ckt,
neutral is nothing but a return
path.....
Earthing is used to discharge a
leakage voltage in the safe
path.........
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the basis for framing the rules of block diagram reduction technique?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
how to calculate singlephase motor efficiency?
Which device is used for the source of emission of electrons in a crt?
what are the steps involved in generator load test?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
write a program that prints prime numbers from 1-20 in digonal form
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
why connecting surge unit in contactor coil
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
what is apparent poewr, reactive power, & active power?
