what is the difference between concentrated winding and
Distributed winding in motor?
Answer Posted / engineer aamir ali
A winding with only one slot per pole per phase is called a
concentrated winding. In this type of winding, the e.m.f
generated/phase is equal to the arithmetic sum of the
individual coil e.m.f.s in that phase. However, if the
coils/phase are distributed over several slots in space,
this kind of winding is called distributed winding. The
e.m.f.s in this case are not in phase but are displaced from
each other by the slot angle. the e.m.f will be the phasor
sum of the coil e.m.f.s.
REFERENCE: Principles of Electrical Machines By V.K Mehta
Is This Answer Correct ? | 33 Yes | 2 No |
Post New Answer View All Answers
Show the schematic arrangement of diesel power station layout and give its principle of operation.
What is Annunciation?
what is high and low cut off voltage of BB and DG at SPS????????
What is EHT tariff or Power factor Tariff ????
Greeting to all members, How to calculate spill current when we have different ratio CT and Class for REF(Low Imp) I have 500/1A 5P20 @line side n 400/1A CL.X @ Neutral.
What is expention fastener (Fan)
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is a fuse? How does it work? What are materials used?
What is center gravity load in substation?
defination of lines
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
what are the factors to be considered while design the breaker either HT or LT??
what is the VA(Volt-amphere)? define with calculation?
How the over load setting for HT Motors calculated-provided in Numerical Relay
if sf6 gas low in gis what will happen