Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amit uapdhyay
it is a critical parameter of designing of orifice. & it must be not greater the .7
unit less a factor defined as === d/D
D- pipe dia
d- orifice plate hole dia.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
What is modbus?
Why humidity limit is 30 to 55 % for raw material storage?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
you are on site,the plant trips,you are approached by operations,what do you do?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Where is wet leg is used?
which type of signal used in instrument?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
How to decrease opening & closing time of on/off valve?
why Fahrenheit unit of moistur analyzer transmitter
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
how to convert cubic metre per hour to newton cubic metre per hour
