Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 18064 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / ganesh
Bcz its loses 'PH' value that is why cool down and
add chemicals to them and again heats. (other
wise turbine may damege)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
the typical output of a solar cell is........
What is stacking factor? What is its approximate value?
what is the formula of starting current of 3phase and 1 phase motor???
Why compensation is necessary in feedback control system?
Define ohm’s law for a.c (alternating current)?
i have a 1500kVA transformer what is the kWH meter i need to use?
How many Zones can be in Conventional type fire alarm system & how can we detect the fire in Conv. type FAS?
What is formula calculation size cable wire ?
what parameters are should nessary for control technic dc drive(in rolling mills)?
define as synchronous generator
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
At what factor resistance r of a conductor depends?
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
how you configure motorvision relay (L&T make)from DCS
redundant connection in contactor?
