Answer Posted / kj

This is done by taking a wire from each end of each winding
to the starter. When starting one end of each winding is
connected to a separate phase and the other ends are
connected together to form a star point.
When changing to delat the ends with the starpoint are
switched open and then switched to a phase each.
Having the correct phases on each end of the windings is
important otherwise the direction of rotation can be
reversed when changing to from star to delta.

What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?

1836

---

please send previous exams question papers

1775

---

What is measurement?

1134

---

working function importance of mdc meter

2115

---

How to address the servo drive for motor

1955

---

what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?

2383

---

State and define ohm’s law?

1096

---

what is RFCT and Insulgard Relay & It's function?

2117

---

We are designer please help me calculate the size of 11kv cables from step up transformer to M.V panel, total load is 5 mega watt distance 900 feet (used aluminum type cables) please provided formula for calculate the cable with example.

1606

---

What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?

1981

---

What is a parabolic signal?

1105

---

whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11

1825

---

can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??

1857

---

In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?

1907

---

What do you mean by dependent and independent voltage sources?

995

---