Interested to Buy Any Domain ? << Click Here >> for more details...
What will be the resultant out put voltage when two
different voltage rating batteries are vconnected in
parallel? pls. answer with example if available.
- 1 Answers
- 3647 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
If two batteries are connected in parallel and have
different output voltages the one with the higher voltage
will try to drive the voltage backwards through the other
battery. This can cause damage to both batteries. For
example a 6 volt and a 12 volt battery. The 12 volt battery
would drive current through the 6 volt battery.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Transmission through a short line depends on
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
why they were using TRIAC instead relay in some controllers and what is the advantages.
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
what are the analog quality input for protection function?what are minimum reqiments?
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
State kirchoff current law?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
how to compute kAIC? with formulas...
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
how to do the ductor test?
